Sign in to follow this  
Followers 0
heidi

replacement part needed.

4 posts in this topic

I hoping someone could help me. we are using DVT Legend 550 cameras and need to replace the power cable part number CBL5-D10. Cognex has stopped making and selling this part. i have tried searching for the components to make it in house but have come up short. if someone has some information on the type of connectors or compatible replacement parts i would appreciate it.

Share this post


Link to post
Share on other sites
This info was never published by vendor SmartImage Sensor Hardware Setup In this section, physical connections to the SmartImage Sensor are explained. This includes powering the system, connecting the communications cable, and connecting to the I/O breakout board. Unpacking and Powering the Legend Series Connect the keyed RJ-45 Digital I/O and power cable to the SmartImage Sensor (typical part number: CBL5-D10). Note: The cable used for The Legend Series 500 has a male 15-pin high density DB-sub-connector on one end and a keyed 10 pin RJ-45 connector on the other end.

Share this post


Link to post
Share on other sites

Yes, that's the 10pin cable.... I've bought some on ebay...  

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0