Jacques

Hi Could somebody please help me, I need the pinouts for connecting the CP1L to and NT2s SF123. Also do I need to change the serial settings in the PLC if I kepted tge screen save.... Help would be grately appreciated thanks.. Jacques.

Hi Hop you are well, did you get an answer for this question yet?

Application is very simple, Barcode reader read a barcoder reader to a pic and the PLC will be linked to the Pic. The pic sends the string to the PLC and the Serials PLC must read the value to a Data memory. At a later stage I would like to use multiple scanners to the pics, where I will use Unit number, but will then worry about the PCMR functions, for now only want to read the value.. Will this be possible. I had a look at the function, RXDU - it looks very simple but at C+1 it asks for the destination Unit address but I don't have a address for the PIC? in the PLC i'm using Port2 and the Unit number is #2.

Thanks for all the help, we've managed to get the comm's working after a long struggle, true the CJ1M Cpu's with build in Ethernet doesn't support socket services, but we used ETN11 card which does. The problem was that we did only monitor the data status that been send across and never the connection status, the Moxa unit must be set to TCP server and an active connection must be establish first with the Moxa unit from the PLC. I do have the code in CX-programmer if somebody needs this ever. Thanks again for all the help...

Hi Hope somebody can assist, I need to transfer data from a Pic18f and a Omron CJ1M plc with and SCU41 card available. The Pic controller can communicate via 485. What do I need to send the Omron PLC serials comm's settings to. (No Protocol, Serial gateway etc.) not to sure what the best way is, I've started to read the W336 and w342 manual, according to what I can see there is many different ways of doing it, what is the best. (PCMR, CMND, RECV etc.) not to sure what will be the easiest. Can somebody please just point me in the right direction? I've managed to communicate a month or two back with a ETN21 and socket services, it there anything available for SCU41 just to manipulate the bits? Regards,

Hi Hope somebody can help me, trying to connect a Moxa RS232 converter to Ethernet convertor to a CJ1M ETN11 through socket services. If you connect the scales to the Moxa unit and open the port via Hyperterminal I can see the weight, but tried to use hard code to open the port on the ETN 11, I think we managed to get this going because the lights is flashing after I trigger the start bit, but if you monitor the status bit the connection is open and close, open and close don't know if the is correct? But the error is gives me is a 4A error which means according to the manual the the unit is not passive. Anybody that might have work with these converter, please assist...

Hi Harald Thanks for the info, after a couple of long nights we got the link going between an Ancient and a new PLC, will do the change over next week.

Hi, Could somebody please help with the pinouts when connecting a C1000 to a C200 via the PC link units. (C500 LK009 TO C200H LK401), and what is the difference between multi level and single level? I want to connect One C1000 to One CS1G.