Sign in to follow this  
Followers 0
Jacques

NT2S SF123 Connecting CP1L M30DR-A

10 posts in this topic

Hi Could somebody please help me, I need the pinouts for connecting the CP1L to and NT2s SF123. Also do I need to change the serial settings in the PLC if I kepted tge screen save.... Help would be grately appreciated thanks.. Jacques.

Share this post


Link to post
Share on other sites
If this is a new NT2 application I suggest you download NTXS 1.04 software at Omron247.com. The old NT2S 1.3c software is really buggy. Download NTxS v.1.04.zip (41 MB) The software also includes the latest firmware for NT2S which you can download to the terminal. If you install NTXS you will find a users manual in the start menu programs folder. The NT2S-SF123 model is powered from the CP1L serial port (I asume you have the option board installed). The cable you need is on page 178 of the manual. Not sure what you mean here... can you explain? Of course the serial settings in the NT2 terminal need to match those of the CP1L serial port...

Share this post


Link to post
Share on other sites
Hi, SF123 does not need programming. set port up (cif01) as default hostlink and connect NT2SCN242V1 cable and you are in bussines. be aware if you create your own cable that the power leads do not cause a voltage drop (high resistance of wires) regards, MPM

Share this post


Link to post
Share on other sites
Hi Did you get this to work? I'm currently struggeling with the same setup, my panel has power but no comm. I've made a NT2SCN242V1 cable accordig to the pinout above. regards Kenneth

Share this post


Link to post
Share on other sites
Post a screenshot of the CP1L serial port setup in CX-Programmer and the NT3 serial port setup in NTXS.

Share this post


Link to post
Share on other sites
My panel is not a NT3 panel but a NT2S-SF123B-EV2 panel, this is a non-programable plc controlled panel. This is my current CP1L serial port setup Regards Kenneth

Share this post


Link to post
Share on other sites
My bad, missed the part where you mentioned the actual NT model.. This model has a totally different pin designation as the above diagram!! See attached for pin designation. I only have a cable diagram for the peripheral port, you should be able to modify it to connect to the RS232 port but I am not 100% sure this will work... What are you going to use this NT2 terminal for? I would at least take a model that is programmable with NTXS... Check this article from MyOmron.com: Getting Started With NT2S-SF123B-E

Share this post


Link to post
Share on other sites
Hi Now it's working This is the correct pinout for a CP1W-CIF01 to NT2S-SF123B-EV2 cable Thank you for all the help Regads Kenneth

Share this post


Link to post
Share on other sites
Excellent! Way to go

Share this post


Link to post
Share on other sites
Hi Kenneth, Do not use this as it is not supported. Cp1L CIF01 has no cmos level drivers and these (CMOS) are the only ones implemented in the Nt2S-SF123BEV2. your connection is a lucky shot but bound to go wrong. please use SF122. regards, MPM Edited by MPM

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0