RPM of motor with sensor pulses on CP1E

[Tarlochan Singh 0]

Hi All I want to check the rpm of motor shaft with proximity sensor on CP1E. Is it possible on CP1E. If yes please help with wiring suggestions TS

[BITS N BYTES 66]

Use the PRV instruction with sensor connected to HIgh Speed Counter input 0. PRV Instruction.pdf

[Tarlochan Singh 0]

sorry i am new user and i am not able to understand can u please explain more PLC settings, How to configure in PLC etc. Thanks TS

[Tarlochan Singh 0]

I have tried above method but not able to get anything on D0 I need help to do the above TS

[Crossbow 295]

How did you wire your pulse input? And what is the speed of the pulses? If you don't get specific about your application we cannot get specific on our answers.

[Tarlochan Singh 0]

Sorry Followings are the details I want to run a motor and giving command by 0-10V for the RPM from PLC to Drive I was taking feedback from 0-10V drive to check the actual running rpm. There is error of 50 to 100 rpm in actual and drive feedback and our application required to display actual rpm on motor shaft. So we dicided to take feedback from motor shaft We fitted one sensor on shaft it is giving one pulse on one revolution of motor shaft Sensor is connected on X0.1 TS

[Tarlochan Singh 0]

MAX rpm of motor is 2880

[BITS N BYTES 66]

As noted in previous post Frequency measurement using PRV instruction only works for high-speed counter 0. Move the sensor to input 0.0 You could also TRY READING THE MANUAL! Frequency Measurement.pdf