Sign in to follow this  
Followers 0
PaulKim1003

need to go online with CJ1M and CPM2A

7 posts in this topic

Hello, Can someone tell me which cables I have to use go online with CJ1M and CPM2A? Can I make them or buy them? And do i use CX-one to go online with the controllers? Any help would be appreciated Thank you for reading.

Share this post


Link to post
Share on other sites

Both CJ1M and CPM2A support Omron's DB9 hardware. (It is not identical to a PCs DB9 hardware.) Therefore you can construct your own cable to use with CX One. See attached diagram. C200HS-CN220-EU Serial Cable.pdf

Share this post


Link to post
Share on other sites
Hello Jay, Thank you for the quick reply ! So this one cable will work for both of them right? Thanks for your time ;)

Share this post


Link to post
Share on other sites
If it is an Omron device with a 9 pin port on it, then the cable that Jay specified will work. Yes.

Share this post


Link to post
Share on other sites
I check the controllers and CJ1M's port is connected with XM28-09 cable abd CPM2A's port is connected with "NUVAL CV9GY". Where are these cables connected to? Do i still construct my own cable to use with CX One? cant i use the cables those are connected with the controllers?

Share this post


Link to post
Share on other sites
The XM28-09 looks like it has a 25 pin on one end. I guess that you could adapt that with a 25 to 9 pin converter and give it a try. I have no idea what the NUVAL Part number is. You could always give it a try....

Share this post


Link to post
Share on other sites
Thanks Michael, I guess if it doesnt work i can make my own cable since it has 9pin port. Thanks alot !!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0