smarius76

MrPLC Member
 View profile  See their activity

  • Content count

    9

  • Joined

  • Last visited

Community Reputation

0 Neutral

About smarius76

  • Rank
    Newbie

Profile Information

  • Gender Male
  • Country Romania

  1. Communication with EasyLogic PM2200 (by Schneider)

    smarius76 replied to smarius76's topic in CX-Programmer

    I use CJ2M with SCU32, Modbus RTU, in the sample is CP1L Modbus TCP. I use function block MRTU_SCU_Master.zip  from this https://www.myomron.com/index.php?action=kb&article=1245
  2. Hi I try to make a communication between CJ2M (with SCU 32), as master, and two EasyLogic PM2200, as slaves, through a modbus RTU communication. I use function block specified  in this library  https://www.myomron.com/index.php?article=1245&action=kb  (I Use MRTU_SCU_Master sample) but no response fom the slave. On Modbus Error code (from function block) appear code 8303 hex. What I am doing wrong. Can somebody help me? Thank you
  3. smarius76 started following Communication with EasyLogic PM2200 (by Schneider)
  4. smarius76 liked a post in a topic: start 2 engines
  5. smarius76 liked a post in a topic: start 2 engines

  6. start 2 engines

    smarius76 posted a topic in CX-Programmer

    Hi, I want to create (and I dont't know how) a programm in CX programmer who start 2 engines alternative. For example: when I press 1 button then start engine 1, and this make all cycle. after he stop, press again same button, but start engine2. I don't want to use counter or ASL instruction thank you in advance
  7. smarius76 liked a post in a topic: Twido and Windows 10
  8. Hi, What is alternative software for programming Twido PLCs in Windows 10. Thank You
  9. Hi I want to make a modbus RTU network between a CJ1M- CPU13 (with SCU 31- V1 module) as master and Twido PLC (who act as slave). I use the protocol made by #Jay Anthony from download section and PCMR instruction in CX-Programer, but i cannot realize the communication. I use, to read from Twido, address 40001 (9C41 Hex). The same protocol and the same CX Programm i use to read from Power Meter PM500 (made by Schneider, like Twido) and work perfect. Do you know any advice to do the network to work in Modbus RTU? Thank you in advance  

  10. Omron and Siemens through ETN

    smarius76 posted a topic in Omron

    Hi, I want to make a communication between CJ1M si Siemens PLC through ethernet network. It's that possible? What setup must i make in Omron or/and in Siemens? I want to read some data from Siemens PLC. Thank you

  11. Omron and Siemens through ETN

    smarius76 posted a topic in CX-One

    Hi, I want to make a communication between CJ1M si Siemens PLC through ethernet network. It's that posible? What setup must i make in Omron? I want to read some data from Siemens PLC. Thank you