Sign in to follow this  
Followers 0
Div_by_zero

controlling GS2, GS3 drives from Do-More CPU via Modbus

3 posts in this topic

I am working on a system where we have several GS2 and GS3 series AC drives that we are controlling with a Do-More CPU via Modbus through a GS-EDRV100 module. I'm to sure where to begin as far as writing the run command and the speed to the drive. Is there a good write-up on this CPU / drive combination somewhere? Thanks for any help! Edited by Div_by_zero

Share this post


Link to post
Share on other sites
Sure nuff! Check out . The GS drives start at #25 on the playlist.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0