Sign in to follow this  
Followers 0
rockyracoon1990

Fanuc robots Hand Broken

2 posts in this topic

Hey, I joined becasue I have what I hope is an easy question that I m hoping I will be able to get help with, because well if I can get this understood I then have to actually set this up for a project. I know that Fanuc Robots have a "hand broken" safety signal that can be enabled to help protect the robot from a crash or during. What I need to know, keep in mind I really know nothing about programming robots, is how to enable this signal in the softaware Fanuc (M-710iC) then If I could have some help with how I would wire in a 3-wire PNP style prox switch to be read by the controller (the sensor will be high until a collision, where it will go low). I was told that it should be wired into the EE connector on Axis 3, does this sound correct? I dont know if that is enough information for any help what so ever, but it is really all I know as of right now. Thanks

Share this post


Link to post
Share on other sites
Does this Fanuc arm have a quick disconnect port near the wrist? Some of the newer arms have a port near the J5 axis for wrist sensor to plug in.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0