Sign in to follow this  
Followers 0
Dr. Kindorf

PID Control for DL06 or GS drive

2 posts in this topic

I have a project where I need to control water pressure by using a VFD and Transducer for the pump. I have used the Koyo PLCs and GS drives extensively, but I one thing I haven't had the occasion to program with either a Koyo PLC or a GS Drive is a PID control. As you know there is always a little learning curve writing a PID operation for different models of equipment, and I have to get this up and running fairly quickly. Would anyone perhaps have a PID routine for this type of control written up for either of these they wouldn't mind sharing? I have a PLC that I will be used for control and signaling, so the function can either be in the drive or the PLC. Thanks...

Share this post


Link to post
Share on other sites
DIrectsoft 5 has a wizard to setup the pid loop. Go PLC -> Setup -> Pid For pump pressure it's very easy to setup the parameters. When online with a plc then you can go View ->Pid View. It will open up a window to tune the parameters to make the pid loop work to your liking (hopefully ;) )

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0