EJ1N-TC4 Temperature Controller stop Output on Alarm

[brk_h 3]

Is there any setting in EJ1N-TC4 that can stop the control output when there is an alarm on any of the channels? I'd like to stop the controller when Loop Burnout Alarm is detected on any one of the channels. Currently, I'm monitoring the status bits from the PLC side and sending a stop signal to EJ1 controller when its alarm status indicates there is an alarm. I'd prefer EJ1N to stop itself when there is an alarm. Thanks.

[Michael Walsh 268]

It looks like this ought to do it:

[Alibaran 0]

On 1/29/2015 at 8:11 PM, brk_h said:

Is there any setting in EJ1N-TC4 that can stop the control output when there is an alarm on any of the channels? I'd like to stop the controller when Loop Burnout Alarm is detected on any one of the channels. Currently, I'm monitoring the status bits from the PLC side and sending a stop signal to EJ1 controller when its alarm status indicates there is an alarm. I'd prefer EJ1N to stop itself when there is an alarm. Thanks.

can you help me? about ej1n

[Alibaran 0]

7 minutes ago, Alibaran said:

can you help me? about ej1n

i cant find address hex run/stop ch1,ch2,ch3,ch4

 

[Alibaran 0]

On 1/29/2015 at 8:11 PM, brk_h said:

Is there any setting in EJ1N-TC4 that can stop the control output when there is an alarm on any of the channels? I'd like to stop the controller when Loop Burnout Alarm is detected on any one of the channels. Currently, I'm monitoring the status bits from the PLC side and sending a stop signal to EJ1 controller when its alarm status indicates there is an alarm. I'd prefer EJ1N to stop itself when there is an alarm. Thanks.

yes.there is setting .you can cheng error alarm by cx thermo