Krzysztof

I solved my problem in easy way. Just reinstalled Cx-Server and now everything works fine like in your movie. Thank you for help. Best regards.

Hello I need your help Sparky. I haven't got omron.opendataserver1 on the list in OPCItemManager. Is this any method to run this or make this active? I do everything as your movie says up to 7:30. Unfortunatelly when I browse LOCAL list there is no OMRON.OpenDataServer.1 and nothing similar (any OMRON drivers). I use Cx-Server OPC V2.1 which is running during I am modifying WinCC project (minimalized in bar, on the right), WinCC V7.2 and Win 7 Pro. I also pressed Test Server when I entered this address liki in 7:08 of the movie. Test was ok (the same window appears and everything looks good). Please help me with this problem if you could.

Thank you Sparky :) I am going to watch this and try with my PLC. Best regards

Hello, Could you help me how to configure connection between SIMATIC WinCC and Omron CJ1G-H PLC. I have installed Cx-Server OPC and would like to read/send data from Omron CJ to WinCC. Do I need additional software besides Cx-Server OPC. Please, help me. Best regards

Hello, In my company I have Omron CJ1 PLC which communicates with devices by DeviceNet and Beckhoff modules (BK5220 + I/O modules). My problem is that I don't understand rules of addressing Beckhoff modules in this network. Are there any constant addresses for remote modules in Omron plc or is it depends on configuration? I know about ESD files but I can't find place in Cx-Programmer where I can look at network structure in my project or see addresses of remote modules. I am really confused. Please help me with my problem. Best regards.