NS communication error

[FET_Destroyer 1]

Hi guys, I'm working on a project that use a NS8 hmi and 3 CJ2M cpus. All the system is connected by ethernet. My question is, if one PLC is offline, without power, a popup message continues to appear always on the hmi. Is it possible to delay for a loooooooong time or even disable the connection timeout error? I change all the settings related to communication and still the warning continues. Regards

[FET_Destroyer 1]

nobody?

[PdL 71]

Try setting Comms auto return to ON. Still, when any of the NS host goes offline, it becomes so slow to operate that it is almost unusable.

[FET_Destroyer 1]

Hi PdL, I think I did that, I'm not sure, It was some time ago, I changed all the fields, and the error was still poping. I will give a try again only with that field OFF. Thanks