Sign in to follow this  
Followers 0
FET_Destroyer

IO-Link protocol

2 posts in this topic

Hello guys, Does anybody used IO-Link protocol with omron cj2m? I have a few sensors from sick that use this protocol, and have more information about the sensor, where I can configure some parameters. In fact, i didn't knew this protocol exists until today, and I've searched on omron website and I cannot find anything relating these two. Regards

Share this post


Link to post
Share on other sites
Hello Well, I'm working on a project that is using IO-Link - first time I have seen it too. We are using Mitsubishi controls, and using a Balluff CC-Link - IO-Link master node, so the programming is largely CC-Link, except for the initialisation of the IO-Link nodes. I think there are other versions of their master mode, so you can probably get <something> - IO-Link nodes, where <something> is some other network protocol besides CC-Link. As far as I can see, it is a fairly new thing, and I don't think there is support for directly connecting to it from the major players yet. But I could be wrong. Hope you get it all working. Cheers

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0