Sign in to follow this  
Followers 0
ah_abodaif

Versa max

8 posts in this topic

Dear All, I have Versa max micro PLC. I can't make communication between my laptop and the PLC. I review the cable and it's OK. I checked Communication data but can't communicate tell now.

Share this post


Link to post
Share on other sites
Make sure Proficy Machine Edition is configured to communicate using the same COM port that your USB/serial converter sets itself up to use.

Share this post


Link to post
Share on other sites
If the problem is not where Steve suggests please tell us: What is the PLC part number? What port on the PLC are you using? What is the part number or pin-out of your cable?

Share this post


Link to post
Share on other sites
Dear Sir, Thanks for replay. PLC part NO is: Versa max IC200UDR164-AD I am using COM3 with communication data 1 odd 19200 and I tried all the possible communication data. The cable pin-out is: DB9F RJ45 1 - 2 4 3 3 4 5 5 8 6 6 7 2 8 1 9 7 The DB9 female numbering is as it's written the RJ45 : the clamp plastic to ground side , the copper pins to sky and the cable in the other side not my side. I tried using Serial communication utility and make test Also Loop back... For my USB to serial I tried to communicate with drives and it's working OK.

Share this post


Link to post
Share on other sites
If the cable is correct, you should veriy IC200CBL500 should verify the USB to Serial device works with PME and the SNP protocol. If those check out it is likely that the port on the PLC has had one or more of the parameters changed by the developer. Did you check documenttaion? I have seen parity changed to "none" and the baud adjusted to match a modem, usually 9600 baud. If the cable was custom made, my bet is there.

Share this post


Link to post
Share on other sites
I already made a lot of cable before and all was working OK. and here the cable Pin out is right as the manual said. also I make my laptop port to default setting and tried all the possible ranges for the baud rate, parity,stop bits..etc. but still same problem. for all thanks for help and I will tell you the solution after i Solved this problem

Share this post


Link to post
Share on other sites
I'm your friend on the site please help me give me possible. Proficy Machine Edition

Share this post


Link to post
Share on other sites
Please contact your local supplier for that. http://support.ge-ip.com/support/ind...S&locale=en_US

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0