Gambit

MrPLC Member
  • Content count

    2599
  • Joined

  • Last visited

Community Reputation

323 Excellent

About Gambit

  • Rank
    Propeller Head
  • Birthday 09/29/74

Profile Information

  • Gender Male
  • Location Amsterdam
  • Country Netherlands

Recent Profile Visitors

15006 profile views
  1. FX5U fixed buffer Modbus TCP

    Why ??? you can do this easlly with the simple PLC comm settings. Ypu don't need any programming   OR if the FX5 is just the server just create a modbus port in the port settings and you're done
  2. You mean comm software like Mx components so you can make something in C#?
  3. MR-J2S displays "AB"

    The servo amplifier was switched on when power to the servo system controller is off. The axis No. set to the servo system controller does not match the axis No. set with the axis setting switch (SW1) of the servo amplifier. A servo amplifier fault occurred or an error took place in communication with the servo system controller. In this case, the indication changes. "Ab" "AC" "Ad" "Ab" The servo system controller is faulty.
  4. Q PLC QJ71Mt91 Communication

    Those are modbus modules which can be master and slave / server client.  Do youn want to use the to communicate with eachother or with a modbus Client ?   Also wich PLC programming software are you using ? GX Works 2? 
  5. A2SHcpu ROM Error Code 17

    Hmm Sorry don't know but i would convert the project to iQ-R\. It's not that difficult. The AnS series is pretty old.    
  6. Analog output fail A1S

    The AnS series is eol. You should consider replacing it with a newer series (system Q or the current iQ-R) it's quite simple.  
  7. Password!!

    if you don't know the old paswords just change to operator and then back again to level
  8. Using bits from a data word with FX3-G

    The FX3G doessn't support this. You can either mov to an array of bits or use an instruction to get the bit value.
  9. No GX Developer in iQ Works?

    Should be part of the installer of GX Works 2. But you shouild be able to install it maually. GX Works 2 installer DVD :\\ GXW2\Disk2\GXD1\setup.exe
  10. A960GOT HMI

    2nd post with the same question
  11. A960GOT HMI

    Looks like it is  not a default mitsubishi Error but one programmed into the HMI. I would readout the project and see which PLC device generates this error 
  12. OS SECURITY ISSUE

    Just reinstall the BootOS it's the easiest So just go to => Communication => Write to GOT => comms settings => Select BootOS from thje drop down and press GOT Write button  
  13. OS SECURITY ISSUE

    You are using level security instead of password security. There was password securirty used in the previous project. Just delete the os or reinstall the Boot OS
  14. MC_Power Power Up Error

  15. MC_Power Power Up Error

    sure you can you just have to set that in the options  Tools = Options => Monitoring => (ladder / ST /..) => monitor Biuffer memroy link memory    Set this to TRUE