MIKE31

MrPLC Member
  • Content count

    173
  • Joined

  • Last visited

Community Reputation

0 Neutral

About MIKE31

  • Rank
    Sparky

Contact Methods

  • Website URL http://
  • ICQ 0

Profile Information

  • Country Canada

Recent Profile Visitors

2995 profile views
  1. Thank you for the reply and info. Mike
  2. HI I have migrated panel builder 32 application into factory talk view machine edition version 6.1 and I have problem . My problem is that screens numbers are not in order, First screen # is 1 the second screen is 12 the third is 6 and so forth. The FTVME does not allow me to correct the screens number based the original application in panel builder 32. Please let me know if you have had this experience and what would the correction method (if any), or it does not really matter if the screen numbers are not in order but application still would run on PV PLUS terminal. Thanks in advance for your time . Mike
  3. DELETION OF MER FILE

    Thanks I meant pc not pv terminal .I have no problem with terminal regarding file deletion . Great help
  4. I want to delete some *mer file IN FACTORY TALK VIEW MACHINE EDITION. I have created mer file of the same application with different names. I have looked some of the AB documentation as well as internet but so far nothing. Thanks for the help
  5. communication with CP1E PLC

    HiI have already done as documented in Omron manual instruction and it is there and no question mark and no unknown devices.It is very strange that can not communicate with processor . What type of cable do you have ,mine is the one that commercially available in market (type B) . Thanks again
  6. communication with CP1E PLC

    hi I have installed usb driver correctly based on OMRON instruction on two laptops and results are the same with the message:FAILED TO CONNECT TO THE PLC. Is it possible that usb cable is bad and how to verify it. Thank you.
  7. communication with CP1E PLC

    Failed to connect to the plc Thank you
  8. HI I have tried few times to go on line with SYSMAC CP1E PLC (usb termina). I have followed the manual , usb driver successfully installed but Communication with plc just keep failing. I have uninstall and install usb driver a few time but no luck with communication .I am running win xp with sp1. Any advice Thanks a lot.
  9. NS ALARM BANNER

    HI . Thanks for the reply. Mike
  10. NS ALARM BANNER

    HI I did upload the NS program and the file is the same.My guess is that message is generated with with the stop command.How do see the all the messages (status or warnings) in NS .Thanks Mike
  11. NS ALARM BANNER

    Thanks again you are right, it is quite possible that the ns program may not be latest version one. I will have access to machine tomorrow morning ,then I will upload it and let you the results.Mike
  12. NS ALARM BANNER

    Thanks for the reply, I did follow your instruction but what I am getting is different than what I am seeing on off line mode.
  13. NS ALARM BANNER

    HI How to see alarms bits and associates description in cx designer off line program. Thanks Mike
  14. cmp instruction

    Thanks for the reply. Mike
  15. cmp instruction

    HI how to write counter PV value as BCD in CMP(20) . Is it cnt 005 #230. I am not sure if this is right .Thanks for the help. Mike