Sign in to follow this  
Followers 0
controltestguy

Calibratiing 140 ATI 030 00

2 posts in this topic

I have the above T/C module that reads 6 deg. high across the board versus a Beta Calibrator. Is there a cal procedure for this module? There are no pots that we can see for calibration. thanks, CTG Edited by controltestguy

Share this post


Link to post
Share on other sites
CTG this is from their website. http://www.telemecanique.com/en/index.htm Do the ARI030 10 and ATI030 00 modules require calibration ? Document Number: RESL2309 Revision: 1.0 -------------------------------------------------------------------------------- Question Do the ARI030 10 and ATI030 00 modules require calibration ? -------------------------------------------------------------------------------- Answer No. Each of these modules employ onboard firmware that will run a continuous self calibration routine. So just a couple of questions: Is this the first time you used a thermocouple module? I see in the setup, you have to tell it where to get the cold junction temperature from - on board or channel one. Which did you select? George

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0