Posted 6 Dec 2022 Logic issue, or problem with Control Expert 14.1? Pop-up box, followed by Control Expert crash. PLC seems to be running fine. "Control Expert Fatal Error" "The thread tried to divide an integer value by an integer divisor of zero" Anybody seen this before? Corrupt file? Reboot? Uninstall/reinstall? Share this post Link to post Share on other sites
Posted 6 Dec 2022 I've not seen it before, but were I troubleshoting it I would. 1. Reboot PC and try again. 2. Repair Installation of Control Expert, not reinstall and Reboot, try again. 3. Call Schneider Tech Support and follow their advice. 4. Re-install and try again. Just my two cents. Share this post Link to post Share on other sites
Posted 8 Dec 2022 On a Schneider FAQ there is a similiar error mentioned. They also mention to repair installation but before this try running the application as administrator first. https://www.se.com/ca/en/faqs/FAQ000134528/ Share this post Link to post Share on other sites