Sign in to follow this  
Followers 0
Guest finian mc guinness

Mac50

2 posts in this topic

Hello, I have a problem using a MAC50 interfaced to an A1n plc. I use GX developer software for the plc and mpp+ for the mac50. I cant get the mac50 to operate in transparent mode. I have spoken to mitsubishi engineers who have ensured that my setups are ok but transparent mode wont operate. Is this a known problem with this interface. thankyou for your replies finian

Share this post


Link to post
Share on other sites
The thing to remember when using GX Developer and Macs is that you cannot change the comm settings in GX Developer. The comm settings for GX Developer to an A-Series PLC are always 9600 8 Odd 1 These settings must be mirrored by the comm port setup in the Mac, whether it is done via Mac Programmer + or via the setup screen on the HMI See attached picture:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0