RJ7EIP91 and R04CPU communication with EX600 by EIP

[zpassha 0]

Good day, how can I communicate with SMC EX600 by Ethernet/IP have you any exemple? I do a setup by EIP configuration tool and write into EIP module but I cant switch any bit into EX600. Thanks

[pcmccartney1 141]

Contact SMC tech support, they have their own Bootp/DHCP tool.  After that you'll need to config the PLC Input, Output and Configuration Assemblies.

[zpassha 0]

Thx for reply, but configuration is ok, but i dont switch any bit or get status in plc, or send bit t9 switch any solenoid

[pcmccartney1 141]

Post your program and one of the true Mitsubishi experts will look it over.

[zpassha 0]

Thanks all the problem is solved. 

EDS file for SMC EX600-SEN3 have bad parameters after correct  unit run perfectly.

[erikryuk 0]

Hi Zpassha,

I having same problem. how you fixed it? could you explain? I'm trying to fix the input and output bytes but I'm not sure if I in correct way.

Thanks in advance