Adam Wright

Nachi to Proface over ethernet/IP

1 post in this topic

Hi

I am trying to connect a Nachi MZ01 robot to a proface (LT400M) HMI/PLC, I cannot seem to get the communications fully working as I have a response error on the proface and a I/O error on the robot pendant, I also cannot find the assembly instance in the manual for the robot to set in the proface device setup, I am using 256 Bytes in inputs and outputs, I have attached the proface software below.

J2204 - Welding Cell V2.prx

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now