Posted 15 Nov 2019 Hi, I am learning on Schneider PLC Programming. May I know is the Schneider PLC Programming have a same function of "Block move" in Mitsubishi PLC which can move a few number of address value to another address in once time. What is the code of it?Example, I wish to move %MW1 (Int) until %MW10 (Int) to %MW100 (Int) until %MW110 (Int). Is there any code can done it in once? I am using Schneider PLC TM241 model with Somachine V4.3 Programming Software. @Wasan, Hi, Do you familiar with Schneider PLC Programming? Share this post Link to post Share on other sites
Posted 18 Nov 2019 @KY WONG I have used Mitusbishi PLC and BMOV instructions but on SoMachine I have not found some function block that similar to them. I think ST (Structured Text) programming are suitable for this condition. For more information please check this link below. https://www.se.com/in/en/faqs/FA278211/ Share this post Link to post Share on other sites
Posted 18 Nov 2019 (edited) Try this Above will move %mw100 to %mw109 into %mw200 to %mw209 Edited 18 Nov 2019 by cHud 1 person likes this Share this post Link to post Share on other sites