KY WONG

BLOCK MOVE VALUE IN %MW#.... TO %MW#... IN SOMACHINE v4.3

3 posts in this topic

Hi, I am learning on Schneider PLC  Programming. May I know is the Schneider PLC Programming have a same function of "Block move"  in Mitsubishi PLC which can move a few number of address value to another address in once time. What is the code of it?Example,  I wish to move %MW1 (Int) until %MW10 (Int) to %MW100 (Int) until %MW110 (Int). Is there any code can done it in once? I am using Schneider PLC TM241 model with Somachine V4.3 Programming Software. 

@Wasan, Hi, Do you familiar with Schneider PLC Programming? 

 

 

Share this post


Link to post
Share on other sites

@KY WONG I have used Mitusbishi PLC and BMOV instructions but on SoMachine I have not found some function block that similar to them. I think ST (Structured Text) programming are suitable for this condition. For more information please check this link below.

https://www.se.com/in/en/faqs/FA278211/

Share this post


Link to post
Share on other sites

Try this

 

move.PNG

Above will move %mw100 to %mw109 into %mw200 to %mw209

Edited by cHud
1 person likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now