GERRY JERESANO

S7 300 BF blinking and SF

3 posts in this topic

Hello.

I am new at Siemens Plc. My problem is after power interruption my S7 300 alarm BF 2 and BF 3 blinking And SF too. I reset the entire system but still BF2 and 3 still on blinking. 
 

What should i do. ? 
 

Thank you.

Share this post


Link to post
Share on other sites

Open STEP 7 and go online with the hardware configuration to see which Profibus or Profinet nodes are not communicating.  If you don't have STEP 7 software, you have to look at all your Profibus or Profinet nodes to see if they have an error indication.  BF means "bus fault", which means one or more nodes on network 2 and network 3 are not communicating.  Could be a cabling problem, Ethernet switch problem, or device problem.

Share this post


Link to post
Share on other sites
On 10/30/2019 at 3:03 AM, GERRY JERESANO said:

Hello.

I am new at Siemens Plc. My problem is after power interruption my S7 300 alarm BF 2 and BF 3 blinking And SF too. I reset the entire system but still BF2 and 3 still on blinking. 
 

What should i do. ? 
 

Thank you.

It sounds like you have a disruption to atleast 2 of your networks (or not configured).

Check your Diagnostic Buffer for further information

 

 

Regards

 

Daniel.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now