Sign in to follow this  
Followers 0
Jesse R

B&R Automation Studio Config Error

2 posts in this topic

Hi,

I uploaded configuration hardware from the PLC, using rs232 serial cable,  made edits to the ethernet module, when I click o rebuild, I'm geeting this error:

Building configuration object "asfw" ...

Building configuration object "sysconf" ...

Error 4819: Hardware module 5PC600.X855-00 is supported up to Automation Runtime version Z3.99. Current version is J4.01.

Building configuration object "arconfig" ...

Building configuration object "iomap" ...

Build: 1 error(s), 0 warning(s)

How do I fix it?

Thans.

 

Share this post


Link to post
Share on other sites

Hi, i have never used B&R software, but i would say you have used a newer version of software to upload the project than is supported by the module.

You may find there is a newer ethernet module available that would work with your version.

I have had similar problems with Siemens TIA. They dont support the older modules as the software is uprevved. E.G, i had a 16  x DI card that i could not configure in TIA V15 because the module was so old. I had to buy the latest released 16 x DI card instead, or use TIA V14. 

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0