Sign in to follow this  
Followers 0
EduardoRmz

Fanuc 90-30 to PacSystems RX3i migration error

1 post in this topic

Good afternoon.

 

I made the migration of a Fanuc 90-30  system to the PacSystems R3XI family using Proficy Machine Edition.

When the migration was made, some error messages appeared:

"" C "block 'CONTROL' requires a rebuild with the PACSystem" C "Toolkit, then delete and re-add the block."

"Instruction BIT_POS_WORD_30 found on rung 7 could not be converted." Reason: There is no room to allow new data to be converted. Check logic and make appropriate changes. "

"Instruction BIT_POS_WORD_30 on rung 7 is not supported by the current CPU."

I try to find a solution to the errors but I can not find an answer.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0