Posted 24 Jun 2019 I am using FX5U-32MT/DS, FX5-40SSC-S and the PLC Open blocks. I am getting an Power-up procedure error status signal. Any suggestions on how to track this down? Or should I do away with block and replace it with Un\G# codes. If so what should I use to make sure the drives are ready? Share this post Link to post Share on other sites
Posted 26 Jun 2019 You are correct. I did not try to accomplish the actual double posting. It was a snag in the matrix. Please delete the second posting. Share this post Link to post Share on other sites