zpassha

FX5U and SMC EX260 built in ethernet

4 posts in this topic

Good day,

I am new in mitsubishi and have a question about how build built in ethernet communication on fx5u fw 1.050 gx3 1.047 with smc ex260 sen1, where i need send 2 bytes and receive 4 bytes can u help me? I try to send data with this format 2#0000000100000001 and send by Ethernet Active Tcp connection library where I have added the external device configuration ip and port SMC EX260 SEN1, I think I needed use a CIP protocol and port 44818 or Ethernet/ip, maybe I need add a ENET module to use this communication between my devices? Thanks a lot for answers

Share this post


Link to post
Share on other sites

Have you already bought the SMC unit. you can get one with CC-Link which would be easiest.

The SMC.....SEN version is for Ethernet IP. so you will need to get an FX5-ENET/IP module

Edited by Gambit
1 person likes this

Share this post


Link to post
Share on other sites

Thank for your reply, you are true, Mitsubishi said the same 

Share this post


Link to post
Share on other sites

I have now a ENET-IP module with new PLC and Can you help me, how to send data to switch any solenoid? What can i do dont work

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now