avik_5156

QJ71MB91

7 posts in this topic

Hello All 

Can anybody help me with the situation that i am trying to communicate the honeywell PID DC1040 series with mitshubishi QJ71MB91 modbus module i have my whole system configuration 

is Q06UDVCPU my plc and 2 nos cc link module 1 nos ethernet module and than my modbus module QJ71MB91 and i am really stuck in this situation from past couple of days please help me to communicate my honeywell pid with the module if possible please share the sample programme and i am using GX works 2 software

Edited by avik_5156

Share this post


Link to post
Share on other sites

Thanks wasan but as per manual it shows that it require GX configurator for modbus is it require also with gx works 2 ?

Share this post


Link to post
Share on other sites

@avik_5156 GX Works 2 has include most GX-Configurator in it. You just Add Inteligent Module to QJ71MB91 then go to its parameter at switch setting then follow step from manual.

Share this post


Link to post
Share on other sites

have you ever tried this wasan will it work definitely?

Share this post


Link to post
Share on other sites

@avik_5156 For commnication setting go to left panel and select intelligent module then go to Switch Setting as shown below.

.QJ71MB91_Setting_01.jpg.ff49752a55b8b169

After that adjust parameter on CH2 (RS-485) to match with slave device parameter.

QJ71MB91_Setting_02.jpg.ae7702a2ab3273fd

Then follow with Z.MBRW instruction in manual.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now