Posted 18 Feb 2019 Good day! Please tell me the options for calibrating the touchscreen of the B & R Power Panel 100 4PP120.1043-31 Rev.K0 without BIOS. After the damage, the touch screen managed to calibrate. After replacing the touchscreen with a new serviceable one, it is impossible to "push" the buttons - you need to start above the button, off-screen. There is no project source. A faulty touchscreen also fails to do a calibration. Can I reset the default calibration settings? Where is the calibration table stored? Is there a way to immediately call calibration after power on? I would be very grateful for any ideas! Share this post Link to post Share on other sites
Posted 23 Apr 2019 We suggest checking the replacement touchscreen as competitive as the old one, if the 4wire around of the touchscreen is different, no matter how to calibrate, the HMI would working in a wrong position or even in a corner. Vicpas provide 1:1 B & R Power Panel 100 4PP120.1043-31 touchscreen glass for replacement, 100% compatitable, and even on need to calibrate Share this post Link to post Share on other sites