B&R Power Panel 100 calibration

[Gellager 0]

Good day!
Please tell me the options for calibrating the touchscreen of the B & R Power Panel 100 4PP120.1043-31 Rev.K0 without BIOS.
After the damage, the touch screen managed to calibrate.
After replacing the touchscreen with a new serviceable one, it is impossible to "push" the buttons - you need to start above the button, off-screen.
There is no project source.
A faulty touchscreen also fails to do a calibration.

Can I reset the default calibration settings?
Where is the calibration table stored?
Is there a way to immediately call calibration after power on?

I would be very grateful for any ideas!

[HMITouchscreen 0]

We suggest checking the replacement touchscreen as competitive as the old one, if the 4wire around of the touchscreen is different, no matter how to calibrate, the HMI would working in a wrong position or even in a corner.

Vicpas provide 1:1  B & R Power Panel 100 4PP120.1043-31 touchscreen glass for replacement, 100% compatitable, and even on need to calibrate