Sign in to follow this  
Followers 0
Gellager

B&R Power Panel 100 calibration

1 post in this topic

Good day!
Please tell me the options for calibrating the touchscreen of the B & R Power Panel 100 4PP120.1043-31 Rev.K0 without BIOS.
After the damage, the touch screen managed to calibrate.
After replacing the touchscreen with a new serviceable one, it is impossible to "push" the buttons - you need to start above the button, off-screen.
There is no project source.
A faulty touchscreen also fails to do a calibration.

Can I reset the default calibration settings?
Where is the calibration table stored?
Is there a way to immediately call calibration after power on?

I would be very grateful for any ideas!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0