Sign in to follow this  
Followers 0
BenEngelen

Groupmove blending problems

1 post in this topic

Hi,

 

I am using a Omron NX701-600 PLC, when doing a groupaxis move there is strange behavior with the speed blending algorithm.

When moving between 3 points(1 to 2 to 3), with the same speed, if the middle point (2) is close to the startpoint (1) the speed is dropping it is not a continuous move...

if the point is further away it does not drop in speed, seems that the problem is due to the acceleration of the first move is not finished before the second move is started...

 

IS this a behavior that has been seen before by somebody else?

grtz,

 

Ben

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0