Sign in to follow this  
Followers 0
Paolo_911

Connect PC through QJ71E71-100

5 posts in this topic

I read through multiple previous posts on this topic, but still can't connect my laptop to a Q03UDECPU using GXWorks2 (Version  1.540N) through an Ethernet switch via QJ71E71-100 card. I can ping the ethernet card, but can't seem to connect at all. Here is my setup:

Q03UDECPU with local QJ71E71-100 module (with I.P. address 192.168.1.10, Network 1 Station 1). The Q03UDECPU is CPU 1 in a multiple CPU setting with another EIP4CCPU module in the rack as well.

TCP > MELSOFT CONNECTION ( x 2 , one for successfully connected GOT and one for my unsuccessful PC), and other TCP connection (For successfully connected MES module)

PC I.P. address: 192.168.1.77 Subnet Mask: 255.255.255.0

Attached you will see all QJ71E17-100 settings and also connection properties with which I am trying to connect. What am I doing wrong? 

 

Enet Settings 1.jpg

Enet Settings 2.jpg

Enet Settings 3.jpg

Edited by Paolo_911

Share this post


Link to post
Share on other sites

Paolo.

The station number for the QJ71E71-100 on the PLC side should be 1...

Change the Station Number on the PC side to 10 then test your connection.

The open settings are regardless for this connection.

 

Regards

 

Daniel.

Edited by collinsd70

Share this post


Link to post
Share on other sites

Oh! Okay, that makes a lot of sense. I was never sure, or never looked hard enough to figure that out (PC vs PLC side). THANKS A LOT !

Share this post


Link to post
Share on other sites
On 12/7/2018 at 11:32 PM, Paolo_911 said:

Oh! Okay, that makes a lot of sense. I was never sure, or never looked hard enough to figure that out (PC vs PLC side). THANKS A LOT !

Thanks for the POST Paolo_911 I have this card and your post gives me some good info to set it up...Cheers

Share this post


Link to post
Share on other sites

I am using a Mitsubishi Q03UDECPU with QJ71E71-100 Ethernet Module.

And I am trying to connect the PLC Via QJ71E71-100 Ethernet Module with 192.168.1.1 , Network No - 1 , Station No. -1 But Cannot Connect.

(And also i am able to Ping the Module at 192.168.1.1)

My Settings are in the attached images.

Please Suggest.

Ethernet Connection.JPG

Network Parametre.JPG

Open Settings.JPG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0