Cabby

Mad42 analog setup

5 posts in this topic

I am trying to setup a MAD42 analog card up in a cpu33 omron controller.   I need input 1&2 setup for 0 to 10 volt and can't get it to work. Any help is appreciated. 

Share this post


Link to post
Share on other sites
7 hours ago, Cabby said:

I am trying to setup a MAD42 analog card up in a cpu33 omron controller.   I need input 1&2 setup for 0 to 10 volt and can't get it to work. Any help is appreciated. 

Please check manual at page 398 - 403 to see example setup.

https://industrial.omron.ca/en/media/W345-E1-11_CS-CJ-Series_OperManual_tcm824-112878.pdf

For Short instructions are

1. Add device at IO Table and Unit setup and select unit no.

2. Setting Input range to 0 - 10 V (and adjust scaling if you need).

3. use XFER to copy data from analog input to DM register (Ex. unit no. 0 are use CIO2005 - CIO2008 for input Ch1 to CH4).

4. Download program and parameter to PLC.

Share this post


Link to post
Share on other sites

My card is unit 1 so i have set 20100 and 20101.  Where can I see raw data from the actual inputs?

 

Share this post


Link to post
Share on other sites
4 minutes ago, Cabby said:

My card is unit 1 so i have set 20100 and 20101.  Where can I see raw data from the actual inputs?

 

For unit 1 raw data should be CIO2015 - CIO2018. It should be shown at IO Table and Unit Setup at Module parameter. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now