Posted 18 Sep 2018 can i replace an existing fx 3g 32mt es plc to fx 3g 32mt ess plc with out altering the sink/ source logic of components connected to the plc.?A servo ,vfd is operating with this plc.. Share this post Link to post Share on other sites
Posted 18 Sep 2018 (edited) ES or ESS is only indicating the power supply of the unit (low voltage DC or high voltage AC), so there should be no problem except you need to change the supply wires and type. Edited 18 Sep 2018 by kaare_t Wrong answer Share this post Link to post Share on other sites
Posted 18 Sep 2018 I would say that the MT/ES is a 100-240VAC PLC Transistor (SINK) output. The MT/ESS is also a 100-240VAC PLC, but with Transistor (SOURCE) output. 24VDC models with transistor output is named MT/DS for Sink, and MT/DSS for Source outputs. 1 person likes this Share this post Link to post Share on other sites
Posted 18 Sep 2018 Sorry for my initial post, I was wrong and @Bryll is correct! Share this post Link to post Share on other sites
Posted 20 Sep 2018 @kaare_t you must be very busy or stressed, you're comments/answers are normally always correct and clear. Share this post Link to post Share on other sites
Posted 21 Sep 2018 @Bryll: Yeah, a bit of both I guess... Share this post Link to post Share on other sites