Sign in to follow this  
Followers 0
a_j_saunders

scanner swap out

2 posts in this topic

All We have 2 identical machines ( vertical form fill baggers ) one of which had some components that have suffered from over voltage etc. we replaced everthing with new items, with the exception of the ab 1747-sn scanner which we borrowed from a running machine. while we were finishing of the inital repair the replacement scanner arrived , this we put in the doaner machine ( after setting the dip switches the same ) powered up machine and we are now getting a coms error on the hmi panel but no fault light on the scanner ( the fault light brefly comes on on power up as dos the green coms light both are off now ) Has any one any Idaes as we now have 2 sick machines !! Thanks Andrew

Share this post


Link to post
Share on other sites
That should not happen with the 1747-SN, because all the configurations are in the SLC-500 program; nothing is saved in the 1747-SN. There were two Series of scanners, and if your program is configured for Series A, I don't think that a Series B scanner will work. Check them both, and check the program. What HMI do you have, and what is the exact error code ?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0