Posted 1 Aug 2018 Posted 22 July · Report post Dear Friends, I want to set my servo controller overload setting as per my machine load requirement since all my servo installed in my machine over travelling and hitting trying to run continuously which is resulting servo failures ,repeated timing belt cut issues.Kindly help me resolve this issue.since i am not familiar with servo controllers.Model used A5 II minas servo MADKT 1507 and contol mode in position control setting. Share this post Link to post Share on other sites
Posted 6 Aug 2018 Not going to get much help on Panasonic if you post in the Automation Direct forum. And without more information about the application and the controller I doubt you can get any worthwhile answers. You never said what is controlling it, are the motors properly sized for your application, what error messages you are getting, etc. Share this post Link to post Share on other sites