Pulse Output - Md212

[GERRY JERESANO 0]

Good Day,

My situation is, i have a flow meter with NPN pulse output, my client wants to have a separate output to be specified a relay output. So i decide to use the pulse output of my md212 since i use it in my pulse input, but sad to say i cannot generate a pulse from my module. i use PLS2 ( 887 ) AND INI ( 880 ).  it is possible not to in able the origin search in the setting since my pulse source is a flow meter? 

[BITS N BYTES 66]

Ignore the settings shown in your picture.

Attached is very useful document. Though written for a CJ1M PLC this also applies to the MD212 module

Although I do not think you should be using a relay on a high speed output!!

 

 

[268]Omron_CJ1M_Motion_Introduction.pdf

[GERRY JERESANO 0]

Thank BITS N BYTES,

The pulse should be 1 pulse per 1 liter. i should generate 20 pulse per batch in may sequence. I use CJ2m - CPU31.