Posted 25 May 2018 Hello all, I need to change the IP setting of a Beijer MAC E1032 text terminal (HMI) without a computer or e-designer software available on location. I know there was in the E100 series a two-button combination to switch manually from run to prog (arrow+home) however it did not work on a E1032 series terminal. This is an other combination but I just forgot what it was because normally I always use the PC for this. Anyone has the answer wich combination it is? Thanks in advance for your help. Best regards, Theo V. Share this post Link to post Share on other sites
Posted 26 May 2018 Hi Theo, For E1000-series the mode is selected by mode switches. http://omniray.ch.sabon.ch-meta.net/tl_files/Katalog/Handbuecher/Steuerungs-UndRegeltechnik/HMI_Bediengeraete/E-Terminal/E1000-Series/HardwareManuals/E1000-Series_ServiceMaintenance_MA00758A.pdf , page 24 Share this post Link to post Share on other sites
Posted 26 May 2018 http://www.cdluk.com/cable-wiring-guides/how-to-e1000-hmi-dip-switches/ 1 person likes this Share this post Link to post Share on other sites
Posted 26 May 2018 (edited) Hi Inntele, this is exactly what i need! I will try this DIP switch setting 1000 as soon as i return to my workbench. thanks and best regards Theo UPDATE: Today I've made a test setup on the workbench. The DIP switch settings were a very easy way to change the network settings, worked fine! Thanks again Inntele! Regards, Theo V. Edited 28 May 2018 by Theo V Update on information 1 person likes this Share this post Link to post Share on other sites