Posted 19 Mar 2018 Hello, I've been wracking my brain, but I thought I remembered there was a way to store and execute a DLL file inside of a ControlLogix (not softlogix) controller? You could use exposed functions inside the DLL to fit your needs. Am I going crazy? Or is this not possible? Any insight into this is much appreciated. Thanks, neech Share this post Link to post Share on other sites
Posted 20 Mar 2018 http://www.plctalk.net/qanda/showthread.php?t=52226 The above thread may help you out. Regards, Garry Share this post Link to post Share on other sites
Posted 20 Mar 2018 @gclshortt That helped somewhat. However, he didn't say what the "special" folder name is. Also, I am trying to do this for a logix controller not SoftLogix. Need to make sure if I include the DLL in the special folder it will download with the program? Thanks, neech Share this post Link to post Share on other sites
Posted 20 Mar 2018 Neech, when I read the thread it says it's only valid for SoftLogix Controllers. Share this post Link to post Share on other sites
Posted 21 Mar 2018 Right, but I thought in my past experience we could do something like this with ControlLogix processors as well... neech Share this post Link to post Share on other sites
Posted 21 Mar 2018 http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/1756-rm003_-en-p.pdf Jump to External Routine (JXR) - This information applies to the SoftLogix 5800 controller only Page 612 in the above manual. Regards, Garry Share this post Link to post Share on other sites
Posted 5 Apr 2018 ControlLogix is not supported. Only Softlogix. Share this post Link to post Share on other sites