Diogo Lopes

Power Flex 753 - Change output relay configuration of Fault

4 posts in this topic

How can the relay output of a PowerFlex 753 I/O module in port 4 be programmed to change state based the fault status of the drive?
What status parameter would you link to monitor the relay output to change.
In the parameters of RO0 output from port 4, I want to set fault state of parameter 935, but it does not give me the option.

Share this post


Link to post
Share on other sites

With most Powerflex Drives, you must enable advanced parameter settings to even access and then modify those parameters.  Find that parameter, then try again.

 

Might be called "access level"

Edited by pcmccartney1

Share this post


Link to post
Share on other sites

do not. even changing the "access level" does not change anything. I'm in software and not in HMI.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now