WSK

Read among of data from NJ to NB HMI

3 posts in this topic

Hello everyone, I am working with a NB10W HMI connected to a PLC NJ by Ethernet protocol, I would like to know where to start regarding the sending of data from the PLC to the HMI. I have a 50x15 array and should show all those values in the HMI for read / write. How to proceed? I started working with PLC for a while.
I'm using Sysmac Studio to programm the PLC and NB designer to the HMI.

Share this post


Link to post
Share on other sites

Hi,

NA HMI is made as 'Sysmac' series product for connection to NJ. NB is not Sysmac product, but can be frigged at least to connect to FINS addresses.

See this video on Omron YouTube channel for steps. The key is adding FINS physical address for the variables in the AT field like %W0.00 and setting to Network Publish

Regards

BB

Share this post


Link to post
Share on other sites

Hi, I've seen this video but I need to pass a lot of information to the HMI (30 cases with 750 variables each), I'm looking for a way to send 750 variables at a time to be read / written to the HMI according to the user's choice.

B. R..

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now