Linty

Error 3300 on Q00J

5 posts in this topic

Hi, I have recently modified a program and hardware and I'm now getting error 3300. I have looked at the fixes on this forum and none have worked so far. The hardware config was 2 I/P cards, 2 O/P cards and a Q64AD card, there is now only 1 I/P card in slot 0 and 1 O/P card in slot 2, the rest have been replaced with blanks. I have uploaded the new parameter and program but I'm still getting error 3300. I've tried clearing memory ( not formatted yet as not sure what would happen). Any thoughts?

Share this post


Link to post
Share on other sites

You have to format the memory as there is still a setting inside (sp.funct) for the Q64AD.

 

1 person likes this

Share this post


Link to post
Share on other sites

Thanks Gambit. I'll give that a try. Is there any way of finding out where that setting is and changing without formatting for future reference?

Share this post


Link to post
Share on other sites

I don't think so. This is the only reason you will need to do a format.
The PLC memory works just like files on a hard drive. It's there so it you won't overwrite it by writing other files.

So you need to remove the file

 

Edited by Gambit

Share this post


Link to post
Share on other sites

Thanks Gambit - that information is now logged and stored in the grey matter.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now