Sign in to follow this  
Followers 0
Allan8020

Programming Analog Outputs - Problems

2 posts in this topic

Hi All,

I've been perusing this forum and I've seen this topic covered before, but I still can't make heads or tails of how to do it still. I'm trying to vary an analog output 10v signal to talk to a VFD according to how much time a certain input bit is energized. Currently I have it set up as a totalising timer, trying to move the PV into a word so I can use it to scale an appropriate output. The trouble is, I'm not having any luck getting the output to do much of anything. No errors show up.

For reference, I'm using a CJ2M CPU 12 PLC and the output I'm trying to program is a DA042V, its in slot 05 of the main rack. I'm trying to scale a 0-20 time to a 0-10V signal out.

I used to have a problem and I was getting ~-.5V out of output 1, but I enabled a bit and now it's hanging out at 0V. Clearly I did something right.

Any help would be much appreciated. I'm sure it's something silly, and I'm new at OMRON PLCs.

Share this post


Link to post
Share on other sites

What unit number (dials on the front) set to?

By the way, you had created duplicate posts, I deleted the other one.  

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0