Posted 16 Sep 2017 (edited) Hi everyone, im using CJ1M CPU21 ... I want to ask how to disable origin search function before I using PWM(891) instruction? This is because i noted that both PWM output 0 cannot share with the origin search function. Edited 16 Sep 2017 by Ong Share this post Link to post Share on other sites
Posted 21 Sep 2017 In CX-Programmer, this is done in the PLC Settings, under the Pulse Output tab. The "Use define origin operation" to be unchecked, which is its default state. Cycle the PLC power after changing any of the PLC settings. Share this post Link to post Share on other sites
Posted 12 Mar 2018 Good Evening Everyone I've been trying to read PWM signals with the MD 212 , CJ2M CPU 31 PLC, i was wondering if anyone could give me some guidance on how to, since this isnt really my expertice field. Thank you very much Share this post Link to post Share on other sites
Posted 12 Mar 2018 On 9/21/2017 at 9:38 AM, Sergei Troizky said: In CX-Programmer, this is done in the PLC Settings, under the Pulse Output tab. The "Use define origin operation" to be unchecked, which is its default state. Cycle the PLC power after changing any of the PLC settings. NO. That's for setting up pulse outputs. For PWM it is NOT necessary to make any changes in the PLC settings. Simply configure the PWM instruction for the relevant output Port and desired frequency resolution [0.1 or 1.0 Hz]. Then use the Frequency and Duty Ratio to modify the PWM output pattern. PWM Instruction.pdf Share this post Link to post Share on other sites