imhassaan

Mitsubishi to Siemens Upgradation

3 posts in this topic

Hi Everyone

I Have to replace Mitsubishi Plc with SIEMENS plc. I am new to Mitsubishi and worked before only on Siemens PLC. I have the uploaded code from Mitsubishi. I am facing problem in Analog Section about data values, Un/Gn, and Analog inputs and Analog Outputs..  Could anyone just Guide me about analog part.  I Upload the analog section below.

 

Thanks in Advance

Analog.pdf

Share this post


Link to post
Share on other sites

You need to give information about the controller model and the analog modules only on the ladder diagram, it's hard to guess it.

Share this post


Link to post
Share on other sites

U/G addresses are used to access the buffer memory inside a special module.  You will need the manual for the special module to see how its memory is arranged.

The U portion of the address is the starting address of the module, such as U3 for the module whose address starts at 30.

The G portion is the buffer number being accessed inside the module.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now