Posted 11 Aug 2017 Hello all I have a folding machine with Omron PLC and HMI NS5-SQ10B-ECV2, the problem is the hmi software disappeared and " No project data" appeared. I contacted the manufacturer and they sent me A single Ipp file. i am not really experienced in omron but i knew that i can upload the soft using CF card so, i used it and switch DIP6 , and the HMI recognized the CF card put it did't see any software. i tried to put the soft in folder with the same name but with no luck. I attached the file he sent me. 出口.IPP Share this post Link to post Share on other sites
Posted 11 Aug 2017 M_M Welcome to the forum. The .IPP file is basically a pointer file to a directory of the same name. The project data is in the directory. The .IPP file by itself will do you no good. Hope this helps. Share this post Link to post Share on other sites
Posted 13 Aug 2017 Ask the manufacturer for the project directory. He may have to zip the directory Share this post Link to post Share on other sites
Posted 14 Aug 2017 Thank for support they have sent another project, but i tried the cf card but with no luck. i searched and i found a way to upload called telnet but i don't know how to do it. soft.rar Share this post Link to post Share on other sites
Posted 14 Aug 2017 SOFT.RAR is a compressed file. Did you unpack the file to the compact flash card? Share this post Link to post Share on other sites
Posted 14 Aug 2017 yes i've unpacked the file in the flash card Share this post Link to post Share on other sites
Posted 14 Aug 2017 Also the CF card is working fine as i used it before to upload the system In another NS5 HMI. Share this post Link to post Share on other sites