how to activate output using cc-link..

[Phillauria Boyz 0]

hello everyone..

i want to know about how to activate a output ( i.e yo, y1 etc ) using cc-link..

[Clear.Mind 18]

For better understanding read this courses - Learning .

Edited 5 Aug 2017 by Clear.Mind

[Crossbow 295]

Nobody can help you.  You have not provided one bit of useful information.

What PLC?  What CC-Link modules do you have?  How is it connected?  What have you tried?

Until you tell us the details, we are not going to sit here and guess...

[Phillauria Boyz 0]

PLC Model is Q00UJCPU

CC-Link Model is QJ61BT11N

Input Model is QX42-s1

Output Model is QX42P

Programming Software Gx Developer Version 8

[kaare_t 155]

You need some sort of remote I/O too. I'm guessing you have connected the QJ61BT11N to the CPU, QX41-S1 and QX42P are also connected to the CPU. What is your remote node?

[NgoHoang 0]

On 8/15/2017 at 5:13 PM, kaare_t said:

You need some sort of remote I/O too. I'm guessing you have connected the QJ61BT11N to the CPU, QX41-S1 and QX42P are also connected to the CPU. What is your remote node?

Dear!

I also CPUQ03 and QJ61BT11N, If I have 1 master and 4 slave, how to send data from master to only slave 3?

Thanks and best regard.

Config Master as below

[kaare_t 155]

You need to calculate where the start addresses are for the specific node, based on the Station Information settings.

For example:

• Slave 1 = 32 I/O Y1000-Y101F
• Slave 2 = 64 I/O Y1020-Y105F
• Slave 3 = 32 I/O Y1060-Y107F

in other words, in the example Slave 3 will have a start digital output address: Y1060