Sign in to follow this  
Followers 0
denise01

MX2 Run signal relay

3 posts in this topic

Hello,

I want to produce an input to CJ1M programme to say that our MX2 Inverters are running using relays AL, AL1 and  AL2 on the MX2.

I believe that setting C26 can be set to 1 for Run Signal and C36 can be set for NO or NC. When I do this the input on the PLC is intermittent so not sure if I can do it this way. Can anyone shine any light.

 

Many Thanks

Peter

Share this post


Link to post
Share on other sites

You are almost there, except that for Run Signal, you need C26=00 instead of 01.

Share this post


Link to post
Share on other sites

Hello,

I tried C26 on 00 before and the input switched on and off very quickly so maybe another setting is compromising it. In the MX2 it states 01 can also be used but same result. Very strange.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0